Paper TF-TuA12
Atomic Layer Deposition-enabled Formation of Laser-Induced Graphene for Charged Membrane Applications

Tuesday, October 22, 2019, 6:00 pm, Room A122-123

Membrane-based processes are becoming increasingly popular for water treatment due to their relatively high energy efficiency and low cost compared to other treatment methods. However, the advantages of membranes are mitigated by the need for additional pre-treatment steps that are required to maintain their effective operation. The treatment and prevention of membrane fouling, in particular, constitutes a large fraction of typical membrane operational costs. One potential approach to combat fouling is to design conductive membrane coatings that can prevent the attachment and growth of biofoulants both electrostatically and via electrochemical generation of reactive oxygen species. Despite their potential, these conductive membrane coatings are often expensive, requiring additional chemicals and non-scalable methods to produce, e.g. carbon nanotube mats or other graphitic coatings deposited by vacuum filtration.

In this work, we explore the use of laser-induced graphene (LIG) for the creation of conductive ultrafiltration membranes. Porous polyethersulfone (PES) membranes are first coated in a thin layer of alumina using atomic layer deposition (ALD) before being irradiated with an infrared laser. We show that this alumina film, which can be scalably produced using spacial ALD, can localize LIG formation to the surface of the membrane, preventing the buried, un-lased areas of PES from melting and losing their porosity during the lasing process. This allows the top-most layer of the PES to be a conductive coating that can be used to charge the membrane surface and used to improve membrane performance (e.g. fouling mitigation). The formation of LIG is verified by scanning electron microscopy and Raman spectroscopy. The conductive layer is also shown to possesses relatively high conductivity, which is important for reducing power consumption in devices. Insight into the mechanism behind the improved stability to melting provided by ALD is provided by thermogravimetric analysis, differential scanning calorimetry, and Fourier-transform infrared spectroscopy. The effect of ALD film thickness and the use of sequential infiltration synthesis will also be explored. These insights are used to discuss the potential application of this approach to creating conductive coatings on other polymers using ALD-based approaches.