AVS 59th Annual International Symposium and Exhibition
    Plasma Science and Technology Tuesday Sessions
       Session PS1-TuA

Paper PS1-TuA8
Plasma Polymerization of Ethyl Lactate

Tuesday, October 30, 2012, 4:20 pm, Room 24

Session: Plasma Deposition and Plasma Enhanced ALD
Presenter: S. Ligot, University of Mons, Belgium
Authors: S. Ligot, University of Mons, Belgium
F. Renaux, Materia Nova Research Center, Belgium
L. Denis, University of Mons, Belgium
D. Cossement, Materia Nova Research Center, Belgium
P. Dubois, University of Mons, Belgium
R. Snyders, University of Mons, Belgium
Correspondent: Click to Email

Biodegradable and derived from renewable resources, polylactide (PLA) has gained enormous attention as an alternative to conventional synthetic packaging materials. Nevertheless, PLA presents high water and gas permeability, which leads to a high degradation rate by hydrolysis of the ester bonds and therefore substantially limits its application for food packaging.

In order to improve the barrier properties of PLA substrate, we propose to cover it with a highly cross-linked PLA-based plasma polymer film (PPF) synthesized by Plasma Enhanced Chemical Vapor Deposition (PECVD). The control of both chemical composition and cross-linking degree would allow to tune the gas permittivity and, as a consequence, the degradation rate of the PLA substrate.

The present work reports on the study of the influences of the experimental parameters (RF power, working pressure and precursor flow rate) on the PPF films properties using a design of experiments tool. The PPF are studied in terms of chemistry and cross-linkage by XPS, FTIR spectroscopy and Tof-SIMS measurements. In addition, in-situ IR spectroscopy is used to probe the plasma in order to get a better understanding on the plasma-surface interactions during the growth process. It comes out that, in our conditions, the applied power is the key parameter controlling the PPF properties. By increasing it, the C/O ratio in the coatings increases from 2.5 to 9.3. The decrease of the oxygen content when applied power is increased is correlated with the loss of O-C=O and C-O functions from 15% to 0 % and from 21% to 5 %, respectively. The in situ FTIR data support this observation and suggest the formation of alkynes in the plasma.